* Sell Intelligent controller of headlamp
* We can provide other Auto Parts,and We have rich experience in foreign trade.

Intelligent controller of headlammp

Product specification:

Rated voltage12V/24V

Rated current35A

Operating temperature-40­­­­­~80.

Functional features:

1. Turn on and off the light automatically

The small light,low beam and high beam of the car installed this controller will be open automatically in order according to the intensity change of exterior light when at dark or entering the tunnel, then they will be off accordingly when at dawn or out of the tunnel.

2. Change the light when meeting one car

The headlight of the two parties will automatically change the high beam to low beam nearly at the same time when they meet a distance of 200~300m at night. After that, the headlight of two parties will revert automatically to high beam( if some cars still come near from the front, it will remain low beam until the end of meeting.

3. Warning if overtaking

When overtaking, it will prompt under high beam that munual high beam/low beam twinkles interchangeably for avoiding the overtaking . In the course of overtaking, the headlight will automatically enter into low beam work mode if one car comes within safe distance, suggesting the driver to stop the overtaking operation.

4. Mode selection

Lighting controls operation with manual/automatic integrated, manual prefered.

5. Turn off the light with time-delay

 It has going-home function( power-off 8~12 minutes, it automatically turns off the light with time-delay).

6. Intelligent upgrade

The product reserves multi-functional interface, which can make intelligent upgrade according to customers requirement.

Installation steps:

1. Firstly,close the key and the power of the car headlight; secondly, open the cover of automotive engine and also open the rear cover of the headlight if the car has already been installed HID, then install the the bulbs and ballasts according to the installation steps of HID. Thirdly,according to the circuit diagram(attached figure 1), input to connect the power of the original car headlight and output to connect the HID ballasts.

2. The car without HID installed should be input to connect the power of the original car headlight and output to connect halogen bulbs based on  the circuit diagram(attached figure 2).

3. After connecting the positive ,the negative and ACC of battery, you should fix the controller to the suitable position by double faced adhensive tape and fixed button.

4. Open the key, check munual/automatic state according to external environment (suggesting to put your hand over the sensor fully because the sensor is 180°sensitization for changing the light ray) and transfer the high beam and low beam.

5. Last, fix the HIC sensor to the top-left of the former windshield or the front of the rearview mirror( notes: for colored windshield, please try to put it below the color in order to avoid the interference to the sensor.

6. The attached figure 3 and 4 are respectively the installation diagrams for matching H4 HID and H4 halogen light.