HOT selling!!! New product!!! Canbus Chevrolet Cruze Canbus Window Closer
New!!! Original Chevrolet Cruze Canbus socket fitting Window Closer Product Descriptions
1. window Closer for the original Chevrolet Cruze cars
2.Canbus technology
3. original socket, easy for installation
4. for 4 windows
5.Can up/down window
Technology Data
Installation:
1.Take the panel apart from the door beside driver, and then find the socket of the power window controller which is same as our wire plug as the diagram showing of the window closer and connect each of them.(Shows as the above picture)
2.Brown wire:trigger signal wire, that’s for connecting the (+) power cable of the lock in the original central locking.
3.The main socket output of the power window closer, for connecting the socket of the power window closer.(Pay attention to the direction)
4.After installation, please use the cable tie to fix the power window closer tightly.( Please make sure the socket which with the cables from the control box downwards).
5.Enclosed here the installation guide as the reference(The rear side).
The working procedure:
After installation, the electronic window is on normal operation when the car powered or started. And at the time when you descend the window, power the car off, take out the key, and lock the door or press the lock button on the remote control, AI window will detect all the windows automatically, and close the windows from the right-back, right-front, &left-back to left-front one by one. And there is a buzzer alert of its mainframe after closing of every window closing.
Installation notes:
Please find the professional technician to install this item, while the technician is fixing the system, and find that the window is not roll up automatically while lock the car door manually or by the remote controller within 3s, then it should to check the following points:
1- If the car is ACC ON;
2- Please make sure the socket of the system is connecting with the car's original socket tightly;
3- If it is installed well by the signal trigger and control wire.
The installation procedure:
A.Take the panel apart from the door beside driver;
B.From the point 1 of the above picture(the power window panel), Then find the socket of the power window controller which is same as our wire plug as the diagram showing of the window closer and connect each of them;
C.From the point 2 of the above picture,connect the brown wire of window closer to the positive trigger wire of the central locking in the door.
Notice:
1- After wire installation, please make sure they are connected well and pack well with insulating tape;
2- Please make sure the socket which with the cables from the control box downwards(Avoid the water coming inside);
3- Fix them tightly with the cable tie, which is avoid the driving without the noise.
