Fiber optic ceiling star kits
1. twinkling and shimmering like galaxy
2. amazing DIY optic fiber light
3. lower power

Fiber optic ceiling star kits 

Compnonets:

1.0mm optic fiber

2. light engine:

Overview:

Daishing fiber optics star ceiling kits provide a complete solution for small and medium size star ceilings, floors or walls. These kits provide everything you need including an illuminator, fiber optics cable and complete installation instructions. The fiber optics cables are pre cut at the factory to greatly simplify and accelerate the installation.

Suggestions:

The appropriate density, or quantity of points in an area, is highly subjective. Most ceilings use between 1 and 6 points of light per square foot of surface area. Lower ceilings (less than 10 feet high) require more density than higher ceilings (more than 15 feet high) in order to look natural. Sparser layouts tend to look more natural, and denser layouts tend to look more glitzy.

Distribution:

Natural stars look splotchy. To best recreate the beauty of the natural sky, we urge you to vary the spacing between points. Some areas should have several stars together and other areas very few stars. Consider incorporating a dense Milky Way section into your project.

Installation:

 Install each illuminator in an accessible location that allows each cable to reach the ceiling with 3 feet of slack. Drill a hole through the ceiling and, working from above the ceiling, insert the proper size fiber through the hole, allowing it to protrude several inches into the room. Secure the fiber in place with adhesive. Allow the adhesive to dry. Clip the fibers to approximately 3/8 from the ceiling and apply a light coat of latex paint over the ceiling and fibers (optional). After the paint has dried, clip the fibers to 1/8, or to 1/4 if you prefer to allow for a future repainting and re-clipping.

Technical Remarks:

Locate Illuminator(s) in an accessible, ventilated area. Route cables to locations of star points. Coil excess cable if needed.

Installation Sequence:

Paint ceiling, drill holes, insert fibers, adhere fibers in place, lightly repaint ceiling, trim fibers to 1/8". Leaving an additional 1/8" would allow for future repainting of the ceiling.

Effective pictures: