synthetic turf artificial grass
1.green artificial grass
2.PE mono fiber grass turf
3.durale synthetic artificial grass turf
synthetic turf artificial grass
1.Product Specification:
Model | DZU83351804 |
Fiber color | 4 tones |
Fiber composition | Polyethylene |
Dtex/Denier | 16500 |
Color fastness | DIN 54004 sale 7 |
UV stability | DIN 53887≥6000hr |
Pile height (mm) | 35 |
Guage (inch) | 3/4 |
Stitches/10cm | 18 |
Density (Tufts/m2) | 18900 |
Pile weight(g/m2) | 2000±5% |
Primary backing | Polypropylene 140g with non-woven 120g±8% |
Secondary backing | Latex |
Roll width (m) | 4±1% |
Roll length (m) | 25±1% |
Application | landscaping |
2.Material:
1.Fiber:Polyethelene monofilament with thatch
2.Primary backing;Polypropylene and woven fabric with drainage hole
3.Secondary backing:SBR latex or PU
3.Feature:
1.35mm high PE monofilament yarn
2.18900 high density
3.No need to infill the sand and rubber
4.Green all the year round
5.Children and pets friendly
6.Low maintenance
4.Why artificial grass:
1.NO WATERING
2.NO MOWING
3.NO FERTILIZING
4.NO WEEDS
5.NO PESTICIDES
6.NO HERBICIDES
7.NO THATCHING OR AERATING
8.NO FADING
5.Installation:
1. First of all assess how much grass you will need. Note: We manufacture rolls in 2 widths: 2 metres (6 feet 6 inches) or 4 metres (13 feet 1 inch)
2. Make sure that the surface to be covered is clean and smooth ready to receive the artificial grass. A self levelling compound available from any DIY store can remove surface imperfections that may show through to the top surface especially on thinner pile height products.
3. Lay the artificial grass on to the clean and level area to be covered. Allow approximately 50mm of artificial grass to trim off to make that perfect edge ie in doorways or up a wall. Leave for around 2 to 3 hours to settle. This helps stop any wrinkling or creasing.
4. Cut and trim your artificial grass, using a sharp Stanley knife making sure are no gaps between walls and grass.
5. Make the joins using the correct type of seaming tape and glue - only quality outdoor tape and glue should be used. We recommend you purchase this from us when placing your order.
6. Apply the infill if required. Typically a sand mix will be used . Rake and spread the infill evenly, taking care not to over fill the surface. Note: Application of sand is best on a dry day. Remember that the infill will eventually compact so you should consider adding a final layer when settled.
6.Production process:
7.Applications: