1, Rapid urinalysis 11 paras
2, High accuracy
3, High sensitivity
4, Easy to operate
5, General Reagent Protein

Instruction:

* Dip the test patch of a fresh strip into urine sample, or pass strip through urine stream-1 to 2 seconds only.

* Blot excess on a clean paper towel or tissue.

* Result may be compared between 1-2 minutes or exposure to urine (Results after 2 minutes are of no value)

* DO NOT touch test areas. Store at temperature between 15 °C-30°C. DO NOT remove desiccants. Be sure to replace cap immediately and tightly.

Collect fresh urine in a clean dry container. Use uncentrifuged urine and mix the sample before testing. The sample should not be more than 4 hours old at the time of testing. Always handle specimens under sanitary conditions.

Note: Urine presevatives may affect test results. Preservatives will not prevent the deterioration of ketones, bilirubin or Urobilinogen. Bacterial growth from contaminating organisms may affect glucose, ph and blood test results.

For a semi-quantitative result red the reagent areas at the time specified on the bottle label. The ph and protein areas may also be read immediately or at any time up to 60 seconds after dipping. For a qualitative result read the reagent areas between 1 and 2 min, except leucocytes which must be read at 2 min. If a positive result is obtained, repeat the test, read each reagent at the time specified on the colour chart. Colour change occur after 2 min are of no diagnostic value.

* Urobilinogen

* Bilirubin

* Ketone

* Blood

* Protein

* Nitrite

* Leucocyte

* Glucose

* Specific gravity

* pH

* Ascorbic acid

At present, there are more than 30 types of General Reagent Protein produced by our company, which widely used to the domestic market and received so much favorable comments from our customers. Furthermore, we can also provide customers with any series of paper pads with specifications from 1 parameter to 12 parameters including MA according to their requests.

STORAGE AND HANDLING PROCEDURES:

For Dignostic Urinalysis Glucose supplied in bottles: Store only in original bottle. Do not remove desicant. Do not remove strip from bottle until immediately before it is to be used for testing. Replace cap immediately and tightly after removing reagent strip. Store at temperatures 2-30°C. Do not store the bottle in direct sunlight. Do not use after expiry date.

Do not touch test areas of General Reagent Protein. Protection against ambient moisture, light and heat is essential to guard against altered reagent reactivity. Deterioration may result in discolourations or darkening of the reagent areas. If this is evident or if test results are questionable or inconsistent with expected results, confirm that strips are within the expiry dates and compare with standard urine.

VISUAL READING TECHNIQUE:

1, Immerse all reagent areas in specimen and remove strip immediately.

2, Run edge of strip against the rim of the container to remove excess urine.

3, Compare test areas closely with colour chart on bottle label or bench reader. Record the results.