Ductile iron pipe T type, T type joint push on DI pipes

Ductile iron pipe T type

 

DUCTILE IRON PIPES:

SIZE RANGE:  From DN80mm to DN1600mm

 

STANDARDS FOLLOW:

 

 

ISO2531, ISO4179, ISO8179, ISO4633, ISO7186, EN545, EN598, BS4772 and other equivalent standards.

EFFECTIVE LENGTH: 5.5 or 5.7 or  6 meters.

WALL THICKNESS:

K9 is the normative one; we can supply K7, K8, K10, K12 if requested.

 

JOINT TYPE: 

The normative joint are Push-on (Tyton-type) joint. Please contact us if other joints are required

 

INTERNAL LINING:

 

Depending on the internal condition of use, the following linings can be applied.

 

Cement mortar Lining: cement mortar lining as per ISO4179, cement can be Portland cement, Blast Furnace cement, Sulphate Resisting Cement, High Alumina cement according to characteristics of conveyed water

Size	Lining thickness(mm)
mm	nominal	min. at one point
DN80-300	3	2
DN 350-600	5	3
DN 700-1200	6	3.5
DN 1400-2000	9	6
DN 2200-2600	12	7

 

  Cement mortar with seal-coat;

Polyurethane;Polyethylene;Epoxy;Bitumen Paint; 

 

EXTERAL COATING:

Depending on the external conditions of use, the following coatings can be applied.

 

Metallic Zinc with finishing layer in accordance with ISO8179-1, with a mean mass of zinc coating not less than130 g/m2 Zinc-rich paint with finishing layer in accordance with ISO8179-2;Bitumen paint, with dry film thickness not less than 70 microns;Polyethylene sleeves in accordance with ISO8180
Polyurethane;Thicker Metallic Zinc with finishing layer;Polyethylene;Epoxy;