Diamond Microdermabrasion
1.Diamond Microdermabrasion
2.Ultrasonic,Photon
3.Skin scrubber
with CE

1. Preface
The Micro-crystal Dermabrasion was designed by Italian
Florence’s Mattioli at first, until now had over 20 years’ history.
This kind of technology only supplies to the dermatology expert
and doctor at first uses, but more and more SPA House & Beauty
Saloon also gradually uses, it was called the best method of
medical beauty. This method successfully has developed in
Europe for several years, cures patient thousands of examples,
and has obtained the extremely satisfactory effect.
Now we want to introduce the Diamond Dermabrasion, it is a
creative improvement of the Micro-crystal Dermabrasion. The
Diamond Dermabrasion provided a non-surgical skin refinish
procedure, by using sterile diamond heads to abrade or rub off the
top skin layer, then Vacuuming out the particles along with any dirt

and dead skin back up. This procedure removes skin debris,
imperfections, blemishes, wrinkles and unwanted pigmentation on
the skin. Moderate usage of Diamond Dermabrasion, accompany
with skin products that penetrate through top skin layer that reach
the dermis level, helps to replenish natural nutrients, restore cell
activity, and promote skin health. The results after Micro
Dermabrasion treatment is usually a healthy, glowing, beautiful
skin.

2. Operating Instruction for Diamond
Dermabrasion
1. Before use the machine, please screw out the output nozzle in
the machine, and then check there is one O-ring attached the
nozzle or not, and also check the cotton filter in the nozzle is new
or not. We recommend exchange the new cotton filter every
treatment.
2. Connect the Silicone hose from the output nozzle to the
Diamond Peel pen.
3. Tight up the Diamond Head on the hand piece. Please make
the Diamond Head connects well with the diamond pen, or else
there is one risk to loose pressure.
4. Turn on the power switch.
5. Adjust the Vacuum intensity by Vacuum Regulator according to
the following reference table, the intensity displays on Vacuum
gauge and check with the client for comfort.

6 Use the incline area of Hand piece to contact with the skin
surface. Proceed with a slow sliding motion. Do not place the
hand piece at one spot for too long, doing so will cause harm to
the skin.
7. Adjust the crystal flow rate by the VacuumRegulator slowly
from minimum to maximum. For commonly use, do not set the
flow rate to maximum unless it is of necessity. This is for better

comfort intensity.
8. Gently stretch the skin with thumb and finger and glide the
Hand-piece 2 to 3 times over the area being treated. Then cross
again in different directions to prevent streaking lines as in the
reference picture. Brush strokes or polishing motions may be used
in different sites.