maternal fetal monitor,baby monitor,multi-parameter monitor,12.1 inch screen
Technical Date
L8P fetal/maternal monitor
Fetal Heart Rate:
Transducer: Multi-crystals, pulsed doppler , high sensitively
Strength: <5mW/cm2
Working frequency: 1.0MHz
Signal processing: special DSP system and modern recognization.
Measurement range: 50~210 bpm
Alarm Range:
High limit: 160,170,180,190 bpm
Low limit: 90,100,110,120 bpm
Maximum audio output power : 1.5 Watt
Toco:
Measurement range: 0~100 units
Maternal SpO2 measure:
Measure scope : 70%~99%.
Measure accuracy: ±3%
Pregnant HR Measure:
Measure scope: 30bpm~240bpm
Measure accuracy: ±2 bpm
NIBP measure:
a) NIBP-SYS (6.7~32.0Kpa)(50~240mmHg)
b) NIBP-DIA (3.4~26.6Kpa)(25~200mmHg)
c) NIBP-MEAN(2.0~24.0ka(15~180mmHg)
NIBP Accuracy: ±1.1kPa(±8mmHg)or ±5% of the results, take the bigger one.
Maximum Mean error : ±5mmHg
Maximum Standard deviation 8mmHg
Pulse Rate Accuracy: Maximum Mean error : ±2bpm
Measure accuracy: ±2 bpm or ±5% of the results, take the bigger one.
Measure mode: Manual
ECG
Heart Rate Measurement and Alarm Range: 15-300bpm
Accuracy: ±1bpm
Heart Rate Average: 8 beats
Lead Selection: II
Input: 5-lead ECG cable
Sweep Speed: 25 mm/s
Amplitude Selection: x1/4, x1/2, x1, x2, x4
Frequency Response:
Monitoring: 0.5 to 35Hz (+0.4dB, 3.0dB)
Defibrillation Protection: 5kV test
Recovery Time Following Defibrillation: Less than 5 seconds
Temperature:
Measurement and Alarm Limit: 0-50°C
Probe: Skin surface
Unit: Celsius/Fahrenheit
Accuracy: ±0.1°C(25°C ~45°C), ±0.2°C(0°C ~25°C or 45°C ~50°C)
Resolution: 0.1°C
Respiration
Measurement Mode: Thoracic Impedance
Respiration Rate: 0-150 bpm
Waveform Display Speed: 25mm/s
Display:
The LCD displays FHR, TOCO, FM , maternal parameters , time, date, volume and so on, It can store and play
back the data.
Power: a.c.100-240v, 50/60Hz or 16.8v Li-ION battery
Power Consumption: < 20W
Dimension: 350W×320D×85H(mm)
Net weight:3.5kg
Packing size:41.3×39-×24.5 (mm)
Gross Weight:9Kg
Environment
Working environment: Temperature: +5°C ~ +40°C
Humidity: < 85%
Atmospheric pressure: 86kPa ~ 106kPa
Transport and storage temperature: Temperature: -10°C ~ +55°C
Humidity: < 93%
Atmospheric pressure: 86kPa ~ 106kPa
Transducer Acoustic Output:
Under the requirements laid down in IEC 1157, 1992, the peak negative acoustic pressure
does not exceed 1Mpa. The output beam intensity does not exceed 20mW/cm2
and the spatial-peak temporal-average intensity does not exceed 100mW/cm2
GEL:
Viscous aqueous non-sensitizing , hypo-allergenic and non-irritating to skin. Indefinite shelf life,
Bacteriostat (not sterile).
3.1 Unpacking the units
3.1.1 Carefully remove the main unit and accessories from the carton.
3.1.2 Check that the content of the carton corresponds with the list below and that all items are undamaged .
1 main unit of fetal monitor
3 in 1 transducer(ultrasound transducer ,contraction transducer, remote event marker)
2 transducer belts
1 mains power cord and adaptor
2 paper pads
Warranty card
1 250ml bottle of gel
Use manua
One Spo2 sensor(option)
One blood pressure cuff(option)