It is mainly used in parking system controlling the parking system.
1. Summary of key functions and applications
1.1 Main features
1.2 Application Overview
Controller uses ARM chips, full TCP / IP network technology, real-time embedded operating system design. Support to non-contact type ID card, IC card or ID card and IC card mix of parking management system. TCP / IP technology for users to install, use, maintenance, upgrades, upgrading and expansion to bring the convenience and fast, has a very high cost.
System can be run offline; the network communication failure, all entrance and exit are still able to work without affecting users in and out.
2. Wiring diagram
3.1 Power connection
NPS100 J1 is power uinterface, connection as the following,
Interface | Spec | Joint | Explian |
J1 | Controller power12V 4A | 1 | Controller power -12V |
2 | Controller power +12V | ||
Card dispenser/collector power 24V 2A | 3 | Card dispenser/collector power -12V | |
4 | Card dispenser/collector power +12V |
3.2Card dispenser/collector connection
Using the 12-pin 2.54mm interface J2 to connect with NPS100 and the card dispenser /collector. NPS100 has been integrated the control which TCD-720F series card dispenser and TCR600 card collector, customer can be matching. Card dispenser and collector interfaces are defined as follows:
Joint | Input/output | Funcation | |
Car dispenser | Card collector | ||
1 | output | +24V | |
2 | output | -24V | |
3 | Input | 0V | |
4 | output | Dispense | collect |
5 | output | Reset | Return card |
6 | Input | Ready to dispense card | No use |
7 | output | Enable | Enable |
8 | output | Callback | Collect card |
9 | Input | Out ok | Collected card |
10 | Input | Lower | Read card |
11 | Input | Error | Card retruned |
12 | Input | Empty | Error |
3.3 DIP switch function chosse
DIP switch function chosse | ||
| OFF | ON |
1 | Entrance controller | Exit controller |
2 | Loop detector enable card read work | Card reader auto enable serching card |
3 | No use | No use |
4 | No use | No use |
5 | No use | No use |
6 | Normal start NPS100 | Force update NPS100 |
7 | Card reader3 interface using as card reader interface | Card reader 3interface using as adjust interface |
8 | Save current setting | Resume NPS100 ex-factory setting |
3.4 Speaker connection
NPS100 provide J6 connection interfaces to speaker. Speaker Specifications: 10W/4Ω. When connect please note the speaker‘s polarity.
3.5 Display connection
NPS100 provide RS485 Interface J11 connection to display screens. Please note that display connection A, B polarity
