RS232 to CANBus Converter
This Converter is for UIM242 stepper controller to network stepper motors
Simplfy CANBus to RS232

RS232 to CAN Converter for Network stepper motor controller

Embedded DSP Microprocessor

Embedded 16-bit high-performance digital signal micro processor

Simple structured, intuitive, rich instructions

Intelligent, fault-tolerating, user-friend interface

CAN2.0B Active Communication

2-wire interface

1 Mega bit/sec operation, long distance

High noise immunity due to differential bus implementation

RS232 Communication

RS232 three-wire serial communication

Max baud rate 112500 bps

Automatic Baud Rate Detection

Wide supply voltage

Wide supply voltage range 6 ~ 40VDC

The UIM250 CAN-RS232 converting controller is used in conjunction with UIM242xx stepper motor controller to provide a RS232 interface on the user side and a CAN bus interface on the motor side (factory side). By using the UIM250 controller, users can be benefited from the advantages of CAN base control network without dealing with the complicated CAN protocol. User only needs to communicate with the UIM250 controller using the simple, intuitive and ASCII coded RS232 instructions. All CAN bus issues are taken care of by the UIM250 converting controller.

Both the UIM250 controller and the UIM242xx controller support network. One UIM250 controller can command up to 100 UIM242xx controllers. Interfacing the UIM250 is simple, intuitive and fault tolerating. Users are not required to have stepper motor driving or CAN protocol knowledge.