1.Reasonable prices
2.According to customers' requirement
3.High quantity
4.Short delively time
5Professional service

Using guide

1.   Coating density and viscosity should be adjusted by solvent content to match the application method, for alcohol based coating, alcohol thinner is used, and for water based coating, clean water is used.  Over dilution reduces suspension stability and brushing properties of coating.

2.   Coating should be mixed thoroughly. In most cases, one brushed application should be sufficient; however, two coats may be needed for larger castings or for specific areas where sand burn-on or metal penetration occurs.  After applying the alcohol based coating, it should be ignited immediately, otherwise lite-off and proper burning may become difficult. In case of difficult burning due to excessive penetration, the coating should be baked using a blowtorch. After applying water coating, the mould and core should be baked well.

3.   Suitable for all application methods: brushing, dipping, spraying, and flow coating.