electromagnetic brake for textile machine
packaging machinery etc
connected and disconnected a short time

 

First, use
DZD2-5A-type electromagnetic brakes, apply to the FA506, FA502 and other types of parking spaces right in the frame when the brake spindle brake. Also applies to other mechanical drive system in the braking position, and other occasions.
Second, the use of terms
Electromagnetic brake to the following conditions, reliable work.
1, relative humidity of the surrounding air not more than 85%;
2, the surrounding medium, not enough metal corrosion and damage to the insulation of gas and dust;
3, and the brake-coil using class B insulation, rated voltage fluctuations of not more than +5% -15%;
Third, the working principle and performance characteristics
DZD2-5A-type electromagnetic brakes are part of the excitation (Yoke, coil, friction-chip) assembly and connection (connection, armature, a spring-chip) made up of two parts (see chart). When the coil excitation power, generate magnetic flux, Yoke pull-in keeper, closed circuit. Thereby creating friction torque, so that the transmission part of the brake. When the coil power, the armature in the spring under the release of the film back, so that the lifting of the brake. The braking device belonging to a single dry, it does not no-load torque, connected and disconnected a short time, long service life, performance and stability, and compact, easy to install maintenance is the best textile machinery in the implementation of automation components.
Fourth, the performance parameters
Brake torque Me: 50N.m access time is not greater than 160ms
Rated voltage DC: 24V off time not more than 100ms
Rated power P20 : 32W to allow the largest relative speed 3000rpm
Fifth, the installation of the structure diagram (Please refer to one or two)

1.link  2.sheet of spring  3.gag bit  4.friction plate  5.coil  6.yoke  7.flange connector 8.axes 9.base  

plan                                plan

Sixth, the installation and use of
1, the friction surface and the surface of armature no oil pollution, to install the necessary pre-cleared.
2, with screw will be fixed in the exciting part of the base, and drive shaft assembly connected to a fixed connection (there should be a rocky ledge axis).
3, exciting part of the face with the armature face air gap between the initial installation work for the δ = 0.5mm.
4, brake use in the process do not need regular adjustments in the work for a long time, due to the wear of the friction surface so that the gap is too large. When the time does not smoke, should be re-adjusting air-gap work.

If you have any inquiry about electromagnetic brake and clutch,please kindly send your drawings/picture with detailed requirement for studying,we can also develop your new own product.

We will give you our competitive price for reference and satisfactory services.