Welcome to B2BAGE
slurry pump
slurry pump

Minimum Order: 0
Quality/Safety Certification: 0.00


Up-to-date General Slurry Pump
CAD Design,Super Performance,Higher Reliability
Super Product,High Quality

USAGE AND FEATURESIn order to fulfill the needs of mining industry, metallurgy industry and so on .we designed and developed WG Series Slurry Pumps which has the features of large flow, high head, multi-stages in series on the basis of our experience in developing pumps and bringing advanced domestic and foreign technique. The main technical features of the pumps are as follows; CAD modern design, super hydraulic performance, high efficiency and lower abrasion rate; Wide passage, non-clogging and good performance of NPSH; Expeller seal combined with packing seal and mechanical seal have been adopted to guarantee the slurry from leakage; Reliability design ensures long MTBF (mean time between events); Adopting metric bearing with oil lubrication, reasonable lubrication and cooling systems to ensure the bearing to run on the status of low temperature; The wet parts are made of special material which has good performance of abrasion-resistant and corrosive resistant; The pumps can be used for seawater ash-removing to prevent it from the corrosion of seawater, salt and mist, and electrochemical corrsion; The pumps can be installed in series with multi-stage within allowable pressure. The maximum allowable working pressure is 3.6MPa

This series of pumps are featured by reasonable structure, high efficiency, and reliable performance. It is easy to examine and repair. They are widely used for handling the mixture of abrasive and corrosive solids in the field of metallurgy industry, mining industry, and chemical industry, special for handling ash and sludge of electric power station.

 

WG(P) series slurry pump is horizontal, single-stage, single-suction, cantilever, double-casing, centrifugal slurry pumps.

 

The wet parts of WG and  WG(P) pump at the same outlet diameter can be interchangeable. Their outline installation dimensions are one and the same. For the drive part of the WG(P)series slurry pumps, the horizontal split frame with oil lubrication and two sets of cooling systems inside and outside has been adopt. If necessary, cooling water can be supplied. The prepared joint for cooling water and the pressure of cooling water can be seen in table1.

 

Two kinds of shaft seal--expeller seal combined with packing seal and mechanical seal have been used for series WG(P) pump.

 

The mechanical seal supplied with high pressure sealing water is recommended when the slurry pump is operated in series (two stages and above tow stages), and the expeller seal combined with packing seal is used in single-stage.

 

NOTICE FOR ORDERING

 

When ordering, it should be stated whether the pumps are in series operation and the stage number in series Otherwise, type WG will be supplied.When ordering, the type of the shaft seal should be stated. Otherwise, the expeller seal combined with packing will be supplied. Generally the protecting grade of the matched motor is IP23 and the frequency is 50HZ it should be stated for the special requirement. Type  WG pump is only used for one or two stages and  WG (P) pump for three or four stages in series operation. 

Ads by Google



About Us | Contact Us | Help | Terms & Conditions
Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2022 B2BAGE Limited and/or its subsidiaries and licensors. All rights reserved.