Welcome to B2BAGE
magnetic drive pump
magnetic drive pump

Minimum Order: 0
Quality/Safety Certification: 0.00


Magnetic pump compact, beautiful appearance, small size, low noise, reliable operation, easy maintenance

CQ type magnetic drive pump (referred to as magnetic pump) is the working principle of magnetic coupling is used to pump new product, reasonable design, advanced technology, with fully sealed, no leaks, corrosion-resistant features, its performance to foreign advanced level of similar products. Magnetic pump to replace the static seal dynamic seal, the pump flow components is completely sealed state, solve the other pump mechanical seal can not avoid the run, run, drop the ills. Magnetic pump is corrosion resistant, high strength engineering plastics, corundum ceramics, stainless steel as a manufacturing material, so it has good corrosion resistance, and can be transported from medium pollution. Use of magnetic materials and the main pump, compact structure, beautiful appearance, small size, low noise, reliable operation and easy maintenance. Can be widely used in chemical, pharmaceutical, petroleum, electroplating, food, defense, scientific research institutions, metallurgy, dyes and other units pumping acid, lye, oils rare and precious fluid, venom, volatile liquid, and equipment supporting water cycle, filter machine matching. Particularly susceptible to leakage, easy, fuel, explosive liquid pumping. Explosion-proof motors use this pump is more ideal.
Install and use one, magnetic pump should be installed horizontally, not erect, the weight of the plastic casing pipe shall bear, special requirements for vertical installation of the occasion, the motor must be upward.

2, when the suction surface above the shaft center line, starting before the valve can open the suction pipe, suction liquid level below the pump if the heart line, the end of the pipeline to be equipped with valves.

3, the pump should be checked prior to use, turn the fan motor to be flexible, no stuck no abnormal sound, tighten the fasteners to be. 4, check the motor rotation direction is consistent with the magnetic pump turning mark.

5, the motor starts, slowly open the discharge valve until the pump into the normal working state, then the discharge valve to the desired opening.

6, the pump stops working, they should first close the discharge valve, then close the suction valve.

Ads by Google



About Us | Contact Us | Help | Terms & Conditions
Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2022 B2BAGE Limited and/or its subsidiaries and licensors. All rights reserved.