Centrifugal Submersible Pump For Agricultural Irrigation
1.capacity :125m3/h
2.cast iron/stainless steel
Centrifugal Submersible Pump For Agricultural Irrigation
technical data
Capacity :10—500m³/h
Head :10—410m
Powr:3KW—220KW
Matched pipe:1.2inch—8inch
Specification of matched Cable:3*1.5²--3*95²
SQS, SQY, SQJ Series submersible pumps widely used in farmland irrigation, spray irrigation and water-use, industrial and civil buildings, also the drainage system to level hills, mountain diversion and in low-lying areas dunes, urban and rural mining supply, drainage and other water conservancy facilities. Characteristics are that they are assembled into a simple structure they have installation convenience a small footprint, simple maintenance and a safe reliable operation.
1.SQS use conditions
(1) Power: 50 Hz frequency and voltage of 380 volts (allowing deviations +5% -10%) of the three-phase AC power. Pumps should be safe submerged operations, diving depth of not less than 0.5 meters.
(2) Water: general corrosion without water, sand volume is not 0.02%, PH: 6.5 ~ 8.5, extracting the water temperature no higher than 30 ° C.
(3) Before the use of motor cavity must fill water, no running water.
2.SQY use conditions
Submersible pumps submerged depth of not more than 5 m; Water temperature does not exceed 40 ° C; water sediment or water insoluble solid mark of the volume ratio of not more than 0.1%, particle size less than 0.2mm, no corrosion, water pH value of 6.5 ~ 8.
3.SQJ use conditions
(1) 380 V bias voltage does not exceed + -5% and 50 HZ frequency, and the deviation is not more than + -1% of the three-phase power supply.
(2) Electrical cavity must be filled with water.
(3) The first-class pump impeller should at least go into the dynamic water level 2 m below surface. Static pump unit immersed under water shall not be greater than 70 m.
(4) Electrical from the bottom of the bottom of the well shall be not less than 3 m.
(5) The water temperature no higher than 20 ° C, QJR-temperature hot water pump up to 80 ° C.
(6) Water and sand content (by mass) of not more than 0.01%.
(7) Water PH 6.5-8.5.
(8) The hydrogen sulfide in water content is not more than 1.5 mg / L.
Features
The motor and the pump united as one, working under water, more reliable.
No special requirements for the well casing and lifting pipe. (It can work in Steel tubular well, lime well, earth well etc. Within the reasonable pressure range, steel tube, rubber tube and plastic hose can be used as lifting pipe.)
Easy to install, operate and maintain, less space demand, no pump house needed
Simple structure, less cost, Submersible
Application
Ground water suction equipment
Water lifting in rivers, reservoirs and Canals
Agriculture irrigation
Water supply for human and animal in plateau and mountain area
Water drainage in city, factories, railway system, mining area and construction site
Water supply equipment in any possible places