1.Meet ISO9001
2.MOQ=1set
3.stock products and short delivery time
4.well diameter :250mm
5.cast iron/stainless steel
Deep Well Water Pump
SQS,SQJ,SQY deep well water pump
Parameters
SQS Parameters:
Flow range10~250m3/h, Lift scope within 5~12m;
Caliber scope 30~150mm, Temperature range<=30° C.
SQY Parameters:
Flow range10~100m3/h, Lift scope within 5~54m;
Caliber scope 51~152mm, Temperature range<=40° C.
SQJ Parameters:
Flow range10~600m3/h, Lift scope within 5~600m;
Caliber scope 32~203mm, Temperature range-15~80° C.
Products Overview
SQS, SQY, SQJ Series deep well pumps widely used in farmland irrigation, spray irrigation and water-use, industrial and civil buildings, also the drainage system to level hills, mountains of diversion, in the low-lying areas dunes, urban and rural mining supply, drainage and other water conservancy facilities. Its characteristics are the electrical, water pumps and assembled into a simple structure, the installation of the demolition of convenience, small footprint, the use of simple maintenance, safe reliable operation, no water pollution and so on.
Product use conditions
QS (SQS) deep well submersible pump use conditions
(1) Power: 50 Hz frequency and voltage of 380 volts (allowing deviations +5% -10%) of the three-phase AC power. Pumps should be safe submerged operations, diving depth of not less than 0.5 meters.
(2) Water: general corrosion without water, sand volume is not 0.02%, PH: 6.5 ~ 8.5 by extracting the water temperature no higher than 30 ° C.
(3) Before the use of motor cavity must fill water, no running water.
QY (SQY) Oil deep well submersible pump use conditions
Submersible pumps submerged depth of not more than 5 m; Water temperature does not exceed 40 ° C; water sediment or water insoluble solid mark of the volume ratio of not more than 0.1%, particle size less than 0.2mm, no corrosion, water pH value of 6.5 ~ 8; If the general temperature of water; water; water; Lake.
QJ (SQJ) deep well submersible pump use conditions
(1) 380 V bias voltage does not exceed + -5% and 50 HZ frequency, and the deviation is not more than + -1% of the three-phase power supply.
(2) Electrical cavity must fill water.
(3) The first-class pump impeller should at least go into the dynamic water level 2 m below surface. Static pump unit immersed under water shall not be greater than 70 m.
(4) Electrical from the bottom of the bottom of the well shall be not less than 3 m.
(5) The water temperature no higher than 20 ° C, QJR-temperature hot water pump up to 80 ° C.
(6) Water and sand content (by mass) of not more than 0.01%.
(7)Water PH 6.5-8.5.
(8) The hydrogen sulfide in water content is not more than 1.5 mg / L.
(9) Water should ensure continued operation of the pump needs.
