Pneumatic Heat Press Machine
1,Two work tables make high efficiency
2, Even Pressure and temperature
3,CE

Features

     using microcomputer intelligent temperature control device \ time integration controller, high accuracy (temperature accuracy of ± 0.5 ° C);

     fever wire heating plate with the overall casting, safety, durability, heat evenly distributed;

     heating plate coated with iron fluoride-long Anti-Burn coating;

     electronic time control, alarm signals completion processes instructions;

     pressure can be adjusted at will;

     floor installation of high temperature resistant silicone foam plates, temperature 350 ° C without distortion.

Technical parameters

     voltage 220V

     Power 2000W

     temperature range 0-400

     Time Control 0-200Sec

     grilled Indian area 38×38cm,40×50cm,40×60cm

     packaging sizes76×46×39cm

     unit weight 35.00 kg

Operating

 1  connected to 220 V plug, the total turn the power switch, power indicator light; (Note that the unit must have reliable protection of ground wire)

2  thermostats adjust to the required temperature (usually 180-200 ° C);

Temperature settings: a bond set by the SET, this time SV window light shine, bond or subtraction by addition bond set temperature, set by the SET to return to complete the interface;

3  the timer will adjust to the time required (usually 40-45 seconds or so);

4  will be clothing-on silica gel plate, and again on pyrograph paper stack (pyrograph paper clothes to the face of a pictorial Transfer Printing part), will be forced under pressure until the handle is completely; (not to pressure over 30 Kg, it could cause a handle deformation)

5  the time when the instructions to the Hot Stamping, buzzer sound, will handle mention returning to the in situ;

6  if it is cold tear the burns the picture paper, I would be grateful if wiping the blackboard clean balance will burns the picture paper again, and so on 5-10 seconds before the burns the picture paper torn away;

7  if the burns the picture paper hot tear, Hot Stamping be completed immediately burns the picture paper torn away.

The success of Hot Stamping need the correct time, temperature and pressure each other to the thickness and material of clothing and pyrograph pyrograph paper types are affected Hot Stamping results. Various pyrograph paper have to try scalding demo confirmed, before mass production.

Maintenance

1  the pressure: if not enough or too much pressure, adjustable pressure Nut, Shun clock direction to increase pressure against the clock to reduce the pressure.

2  Time: When the time arrived Hot Stamping not ring for the buzzer to sound or keep required inspection of the tail compartment switch contact point fretting whether moderate, if not suitable for a suitable position to be adjusted.

3  temperature: preheating about 15 minutes, when the temperature reached set temperature, heating lamp eliminate, beginning Hot Stamping; fever plate for a few minutes if not boot fever, please check lines.

4  when the handle pressure down in the end, opening up and hand to handle automatic recovery,

I would be grateful if the above heating plate downward adjustment nut adjustment when Hot Stamping completed, up to handle sensory difficult, it can be adjusted upwards Nut adjustment.