4-channel wireless remote control switch with wireless transmitter
1.Working current : 8mA
2.Working voltage : DC12V

4-channel wireless remote control switch with wireless transmitter

  KL-K400C Specification & user manual

Technical parameters:

12V Quad Power Controller KL-K400C

Working current: 8mA

Working voltage: DC12V

Operating Frequency: 266-433MHZ

Receiver sensitivity: -95db

The encoding type: learning type

Working mode: non lock, interlocking, self-locking( adjusted by jumper hat)

Maximum load: 7A

Size 49 * 69 * 20MM

USER MANUAL

KL-K400C 4 Channel Remote Control Switch With Remote Control

1. Programming

Press learning key for 3s, the indicator light flashes, then press any button of the remote control, the indicator LED goes off, the remote is set. Up to 20 remote controls can be paired.

2. Deleting the remote control memory

Press the learning key for 3 Seconds until indicator LED fades, then then release, Memory is now deleted.

3.Output mode

Unlocking, self-locking and interlocking. S1 & S2 program the sequence as follows: S1→ self-locking

S2→ interlocking

No Jumper on S1 &S2→ Unlocking

4. Wiring

On the back of receiver board marks: K, G, and B

K is normal open connector

G is Common connector

B is Normally closed connector.

5. Modes

1) Self lock model

Press remote button A , the receiver relay is on, press button A again the receiver relay is off, the same as B/C/D.

Extend function:

(When jumper is off position) press A on the transmitter, receiver A goes on 2 seconds, then goes off automatically, same of B/C/D.

2) Non lock model

Press remote button A, the receiver relay is on, release button A; the receiver relay is off, the same as B/C/D.

3) Interlock model

Press remote button A, the receiver relay A is on, the relay B/C/D is off.

Press remote button B, the receiver relay B is on, the relay A/C/D is off.

Press remote button C, the receiver relay C is on, the relay A/B/D is off

Press remote button D, the receiver relay D is on, the relay A/B/C is off.