12V Controller for Touch monitor
1.Applicable to the touch driver above 26" SAW
2.USB or RAS232 ports both available
12V Controller for Touch monitor
Supply Voltage | +12V DC(+ 11V ~ + 13V) |
Supply Current | 85mA (+12V DC) |
Power must supply 200mA at least. | |
When frequencies below 1MHz, the peak of the total noise and fluctuations must be less than 100 mV; frequencies above 1MHz, the peak must be less than 50 mV | |
Interface | USB 1.1 |
Resolution | 4096x4096, z axis 255, size independent |
Conversion Time | Approximately 16 ms Per coordinate Set |
Reliability
| MTBF greater than 200,000 hours According to MIL-HDBK-217-F2 using the part stress calculation method for ground environment with an ambient temperature of 40 °C |
Temperature
| Operating Temp.: 0°C to 65°C Storage Temp.: -25°C to 85°C |
Humidity
| Operating Humidity: 10% ~ 90% (no dew falls) Storage Humidity: 10% ~ 90% (no dew falls) |
ESD
| EN 6100-4-2 1995: Meets Level 4 (4KV air/ 8 KV contact discharges) |
Flammability
| The PCB substrate and all plastic components, such as headers and connector are rate UL 94 V0. |