Crusher
Good helper.
using for All kinds of crops straw
(moisture content acuities 15%),
corn, all sorts of grain.

Crusher

1.product structure and working principle

This machine is composed of the motor, rotor cutters, spiral shell, motor base, dust cyclone, thin wind pipe , into hopper, double discharging tsui composed, the component such as its working principle: straw by into hopper feeding, rotor blade material cut off, first by high speed rotating hammer of blow and sieving slice collision, rub the role and the rapid shatter, crushing the powders after by centrifugal and rotor blade rotation generated by wind pressure and rapid screen hole waft to set powder bag or aggregate indoor.

2. specifications and technical parameters

3. installation and debugging

(1). The machine installed directly on level ground, need not fixed.

(2). Before installation should be inspected

(3). the integrity of the machine parts

(4)all fasteners, hammer of shaw shaft, and his mouth is strong. Such shaw

(5). Motor starter and panel must put the machine accessories, do not use more than motor rated current of the fuse.

4. using method

(1). Will installation debugging good crusher in empty load, and then starting idling 2-3 minutes will feed. Manual feeding, feed amount to ensure uniform, work under rated load motor, such as feed, when overloaded suspension for returning to normal after continue to feed. Hand over the warning line is strictly prohibited, and pay attention to safety.

(2). Material feeding ended, let crusher continue sports 1-2 minutes, all the materials in the standby crushing side by side to set powder bag again after the stop.

4 .maintenance

(1). The hammer of the main parts is crusher, after wearing whether in exchange, exchange edges u-turn angular or replacement for new hammer of all or, are to be all the hammer of simultaneously. Never allow individual replacement, or adopt new for the old replace method. Each installation should keep the original permutation method, and pay attention to every hammer of (new hammer of) weight tolerance weight is not more than 3 grams.

(2). The screen piece to timely inspection is vulnerable parts, such as part of the screen piece, can break behind weld-repair and rivet on up, if damaged, it shall promptly replace new sieving slice. Replace new sieve hole in one hour should pay attention to the screen with burr side down.

(3). Long-term need not when, should the machine cleaned up and stored in the dry place save in case motor damp.

8. safety operating rules

(1). Installation, use this machine, the operator should perusal before this instruction manual machine, familiar with the performance, structure and using method, and according to the requirements of this instruction manual installation, commissioning and use and maintenance.

(2). Crushing kang powder materials must dry (more than 15%) and to remove moisture content such as metal and stone, put clean place. Abvance

(3). Should check before starting the machine without foreign body, fasteners and within the firm, such as open shaw whether rotor rotating is flexible, without collision phenomenon.

(4). Boot empty revolve 2-3 minutes, turning to correct, functioning normally can feed. The operator can stand in feeding mouth the left feed uniformly, moderate, forbidden reached into feed hopper dial the material and, when necessary, usable nightsticks or branches to help feed.

(5). Work if discover not normal phenomenon (such as: violent vibration, clash, motor fever, jam, etc.) should immediately stop check, stay troubleshooting rear can work.

(6). When set powder bag accumulated powder long 1/3 (bag length p 6 meters) shall immediately take powder, lest affect exhaust, reduce production, take flour and work should be often jitter bag, increasing permeability.

(7). Warning! The age of 16 young and old aged 55 and don't understand the machine operation requirements of the personnel cannot separate operations.

(8). No drunken, those duties, excessive fatigue homework alone.

(9). The machine to work after 200 hours should check the rotor wear, such as the discovery of pin shaft, hammer films, cutting knife, open shaw, etc, crack and abnormal should be replaced immediately, lest produce severe damage and death or injury.