1.Wide voltage input(15-60VDC)
2.High frequency output function
3.directly connected to the solar panels
4.small volume
GTI Series Inverters For Grid
1.high-frequency transfer, smaller volume
2.high-performance MCU manage
3.high-performance MOSFET quick driver, more efficient output
4.high-performance SPWN manage
5.single channel and high-frequency combining(38KHz)
6.single channel and half-wave zero level change combining(50/60Hz)
7.under-voltage alarm function
8. under-protection
9.over-load protection
9.short-circuit protection
10.over-voltage protection
11. pure sine wave output, adapt any laden
12.soft boot output
13.over-temprature protection
User Guide:
Installation and connection
Red terminal: Connect DC positive, black terminal: Connect DC negative
AC socket: Connection to the laden
Switch: power properly connected, turn on the switch, the inverter to work
DC input:
Input voltage range: 9.8V to 15.5V
Maximum input voltage: 16.5V
AC output:
Power grid connect”
220V AC versions: 190V-250V 50Hz
110V AC versions: 90V-140V 60Hz
LED indicator:
Red LED: into protection
Installation Connection
1.Red terminal: Connect DC positive, black terminal: Connect DC negative. Shown in Figure 1
2. AC socket: Connection to the mains. The AC cord to the inverter 3 foot outlet, then the AC cord to home 3PIN AC outlet. Are shown in picture 2.
Picture 2 Figure3
3.Switch: power properly connected, turn on the switch, the inverter to work.
Notes:
---Please pay attention of the voltage when use the product. The voltage is from 10.5—28V, if is not these voltage the product may broken.
---Recommended Maximum DC input 4AWG cable capable of handling more than 50A of the cable size.
---Optimal length of the DC input line 8M or less, long cable will allow solar panels to the inverter DC voltage drop caused by wear and tear.
---Connected to a power outlet to provide AC
---Connected solar panels, battery or wind generators DC input DC power supply cable.
---Proposed wind power plant with its own charge controller and load dump
