XU-serise Precision Oven
1.Test temperature thermostat
2.Fan-forced convection
3.Temperature fluctuations less than+/- 0.2C

XU-serise Precision Oven

XU-serise Precision Oven High-temperature thermostat for metal, rubber, plastics, paints, and various electrical and electronic products, such as high temperature thermostat test;
All laboratory oven fan forced convection are used to ensure the accuracy of temperature control and reduce the temperature deviation;
Temperature fluctuations of less than ± 0.2 ° C. Rapid heating heating time, low long-term use to maintain the surface temperature of the shell.

Operating Environment:
High-temperature thermostat for temperature RT + 10 ° C to 200 ° C or RT +10 ° C to 300 ° C high temperature thermostat test, different according to different maximum temperature and the heating element insulators. Temperature fluctuations of less than ± 0.2 ° C. temperature is less than the value of the special floating ± 1.2 °C (105.0 °C) (EU NFC15-140 international standard test method: sensor with nine points in nine different two-hour The standard test) to quickly heat up the heating time, low surface temperature of the shell.

Introduction:

High-temperature thermostat from 27 to 980 liters volume of 10 to choose from. Cavity with a corrosion-resistant stainless steel material, the internal shell of polished steel, spraying paint with epoxy paint (light gray) no contact between the inner and outer case, using the most optimal isolation, to reduce the consumption of thermal diffusion and heat the outer wall and door with rock wool, insulating layer thickness of 70mm, to ensure their effective operation and temperature stability. Silicone rubber gasket provides the best seal between the door and the cabinet. The insulation and the gasket does not contain asbestos. Right outside the door set to open design, and operations to facilitate the placing of oven.

Heating:

Tubular heat, coated stainless steel heating element, a reasonable installed around the fan. Wear-free switch (solid state relay) control the heating element.

Internal:

All the laboratory temperature thermostat fan forced convection are used to ensure the accuracy of temperature control and reduce the temperature deviation. Cooling fans and heating elements are hidden in Stainless Steel Shelves, the (even more attractive platform for this work and do not occupy the space) after the air from the central cavity back into the fan to pass through the sensor temperature, and then through the heating element, heated air into the cavity at the Shelves around the left and right, and then re-circulated by the fan.

Temperature control and security:

Thermocouple temperature controller. Temperature Precision by the microprocessor circuit board to control, through the microprocessor to improve the temperature accuracy and prevent cavity temperature exceeds the set temperature. The thermostat can be adjusted independently over-temperature protection limit, which provides for the equipment operator 3.1 standard of protection. PID auto-tuning digital controller, digital display setting and actual temperature values, and the heating light switch button on the control panel, when the malfunction indicator light, said safety device to work.

Exhaust air, fresh air supply:

Fresh air before entering the cavity through the vent to warm up. Set up a 30mm diameter exhaust vent, through the adjustable valve to control emissions.

Ancillary equipment:

Shelves can be placed placed to adjust the level of material, can also choose to hold place. If necessary, additional Shelves. In the left side of the oven have a standard diameter of 20 mm channel, the channel is equipped with a rubber plug.