High viscosity,anti-slip,water-resistant,flexible,specially for cement EPS/XPS insulation board
Short introduction:
The product is one adhesive material especially for plastering the polystyrene board on the wall or roof.It is cement-based powder material, can be used after adding water.
The product has the following characteristics:
high bond strength,has anti-sagging performance
waterproof and elastic
Application range:
adhesive for EPS or XPS board of exterior thermal insulation serialsadhesive for roofing thermal insulation board
Technical performance:
project | performance | |
Tensile bonding strength(Mpa) | Original strength | ≥0.60 |
waterproof | ≥0.40 | |
Tensile bonding strength(Mpa) | Original strength | ≥0.10 |
waterproof | ≥0.10 | |
Open time(h) | ≥1.5~4.0 |
Base demands:
Applicable to all kinds of cement mortar surface,brick surface,concrete surface treated with interface treatment.The base surface should be clean,no oil,dust and other dirts.The product can not be used until the cement mortar surface dried.
Constuction points:
1,Mix by the proportion of weight:the product:water=5:1.Add clean water into clean container,stir while add the product ,to uniform thick paste,put it aside for 5 minutes,stir it once again and can use.No water when stir the second time
2,The adhesive can be coated by point and ring or sripe.also can be coated directly on the base surface,and then paste the polystyrene board in right place.
Dosage reference:
By Full coating thickness 3 mm,the theory dosage is 4.5kg/m2
Attention:
1, This product should be mixed with the mixer at the speed of about 400rpm
2,stir once at the half amount of the packing
Packing and storage:
The product is 25kg/bag.Keep it in dry and cool place.It can be stored for 6 months from the date of production