1,LED Quantities:12/18
2,Power:12w/18w/36w/54w
3,Have the Wall hung type and the Push-in-Wall type
4,AC12V/24v

Product Name: RGB LED Swimming Pool Light

Item no: KW-PAR56-18/12 Series

Working Power Supply: AC/DC12V/24v

LED Quantities:12pcs/18pcs

Wattage:12w/18w/36w/54w

Have the following can choose :

A :No houseing par56

B:Stainless cover-wall hung type (white and Blue color)

 

C:ABS Cover -wall hung type

 

 

D:Stainless cover -put-in-wall type E:ABS COVER -put-in-wall type

 

Also have the following other can choose the power and LED quantities

1, 10W 2.13W 3.18w 4.19W 5.22W 6.24W 7.35W 8.40W

LED Quantities:

1, 144PCS 5mm RGB LED lamp

2,183PCS 5mm RGB LED lamp

3,252PCS 5mm RGB LED lamp

4, 270PCS 5mm RGB LED lamp.

5, 324PCS 5mm RGB LED lamp.

6, 351PCS 5mm RGB LED lamp.

7, 501PCS 5mm RGB LED lamp

8, 546PCS 5mm RGB LED lamp

8, 558PCS 5mm RGB LED lamp

 

Light Color: RGB&singel color(W/B/G/R/Y)

*for the singel color,we have White,bule,green,red,yellow to choose*

Length: 178*100mm

Lighting Angle:: 60 degree

Water Protect:IP68

Lifespan: >50000 hours

Ambient Temperature: - 20~45°C

Heat Sink: housing temperature less than 40 degree,

 

Manual of Underwater light

 

 

Instructions of remote control

RGB gradient change illuminated in the first power on or press button “D” to turn on the lightSwitch off/on the power each time,the color will be changed with following sequence:Red→green→blue→RGB→RGB gradient change slow→RGB gradient change fast→disco mode slow→disco mode fast→The speed is constantly changing on the flickering effectInstructions of remote control

1) Continue pressing the button “A” to make the 3 group led change in seven stages:Red→green→blue→red+green→red+blue→green+blue→RGB

2) Continue pressing the button “B” to make the 3 group led change in 3 modes:

RGB gradient changeDisco modeBlinking change

3) Pressing button “C” to adjust the speed of “A” and “B”

4) Pressing button “D” to switch on/off the led light

5) It will reset in 5 seconds after power off

6) The remote control can operate many led lights synchronously

Installation procedure

Screw the bracket into the wallMount the clip of the bracket into the hole of the lightScrew the detailed illustrations in the below pictures

Cautions

Work with AC12V, otherwise the light will be possibly damagedThis light should be installed not deeper than 50cm underwaterThe power wire of the lights shall be joined with other power wire out of the water. Waterproof treatment should be done if the joint is in the water otherwise there is risk for water intrusion. The light should be in the water for the test of remote function or other functions, and don’t test it more than 3 minutes out of the water otherwise the light will be possibly damaged or caused disfunction . If the user is not available to test it in the water, then please shut off the light every 3 minutes to be cold for the new test